Garage Door Spring IPPT Calculator

IPPT (inch-pounds per turn) is how much torque a torsion spring adds for each turn. Find the IPPT of a spring you have, or find every spring that gives the IPPT you need.

How to
How to
How to
Your door (sets the turns)
ft
in
Rate this calculator

What is IPPT on a garage door spring?

IPPT stands for inch-pounds per turn: how much torque a torsion spring adds to the shaft for every full turn you wind into it. It is the spring's strength, and it depends on three things you can measure: the wire size, the inside diameter and the length of the coils.

From IPPT to door weight

Multiply the IPPT by the number of turns to get the torque on the shaft, then divide by the drum radius (2 inches on a standard 4 inch drum) to get the weight that spring balances:

lift (lbs) = IPPT x turns / drum radius

Example: a .250 x 2 x 32 spring has an IPPT of 36.88. On a 7 ft door with a 15" radius track and 4" drums it is wound 7.94 turns, which puts 293 inch-pounds on the shaft and balances 146.4 lbs.

From door weight to IPPT

Turn the same sum around to find the IPPT each spring needs:

IPPT per spring = (door weight / springs) x drum radius / turns

Example: a 180 lb, 7 ft door on two springs needs 90 x 2 / 7.94 = 22.68 IPPT per spring (7.94 is rounded; the calculator uses the exact turns). Choose "I need an IPPT", then "A door weight", and the calculator lists every stocked spring with that IPPT.

Why IPPT is the number to match

Two springs with the same IPPT, wound the same number of turns, lift the same weight, whatever their size. That is how a spring is replaced with a different wire size, or one spring with two: match the total IPPT. The spring conversion calculator does that from the springs on your door, and the spring chart shows common sizes at a glance.

Torsion springs are under high tension. These numbers tell you what to buy; winding and installing springs takes proper winding bars and training. If in doubt, call a garage door technician.

Frequently Asked Questions

What does IPPT mean on a garage door spring?

IPPT means inch-pounds per turn: the torque a torsion spring adds for each turn wound into it. It sets how much weight the spring can balance at a given number of turns.

How do I calculate the IPPT of a torsion spring?

Measure the wire size, the inside diameter and the length of the coils, and enter them in the calculator. The standard formula uses the wire size to the fifth power divided by the coil diameter and the length, so small changes in wire size make a big difference.

What IPPT do I need for my garage door?

Divide the door weight by the number of springs, multiply by the drum radius (2 inches on a 4 inch drum) and divide by the turns (about 7.9 for a 7 ft door, 8.8 for an 8 ft door, on a 15 inch radius track). A 180 lb, 7 ft door on two springs needs about 22.7 IPPT per spring.

Do two springs need the same IPPT?

Usually yes, so the door lifts evenly. What matters for balance is the TOTAL IPPT of the set, which is why a single spring can be replaced with two that add up to the same IPPT.

Does IPPT change with door height?

No. IPPT belongs to the spring. A taller door needs more turns, so the same spring balances a little more weight on a taller door; the calculator works that out from the height, track radius and drum.